Product profile and use
Vissla 7 Seas 3 mm Wetsuit Hood – Size M extends a wetsuit setup with focused protection for the head and ears. The stated thickness helps match it to water, wind, personal cold sensitivity and the rest of the equipment.
A hood only works as intended when it fits correctly. A loose opening can allow water movement, while excessive tension creates pressure at the forehead, chin or neck. Head size, face opening and the transition to the suit should be considered together.
Verified features
- flexible Super Stretch neoprene
- heat-insulating, fast-drying thermal lining
- glued and blindstitched seam construction
- wind-resistant Duramax exterior
Fit and selection
The face opening should sit evenly without restricting vision or breathing. Position the neck section as intended with the suit. Before entering the water, test head movement, chin position and sealing without accepting excessive pressure.
This item is listed as Size M. Compare the selected variant with the manufacturer's size chart and your body, hand or foot measurements before ordering.
Use and care
Rinse the product inside and out with fresh water after every session. Dry it inside out first, then fully in the shade; avoid heaters, tumble dryers and direct sun. Close hook-and-loop areas, avoid sharp folds and store only when completely dry.
The right choice combines product construction, exact size and real conditions at the spot. Air temperature, wind, activity level and personal cold sensitivity change insulation needs. For long or very cold sessions, plan the complete wetsuit setup as one system.
Before the first session, inspect seams, edges and material surfaces. Address wear or damage early and use the product only for its intended watersports purpose. This makes fit, function and service life easier to manage.
Product safety information
Manufacturer information:
Stokehouse Unlimited
Avenue des Rémouleurs 584
Nouvelle-Aquitaine
Soorts-Hossegor, Frankreich, 40150
info@visslaEU.com
German
Danish